Appendix 3 Stopping And Resuming Status Of Dvd - Denon DN-V310 Instructions Manual

Appendix 3 Stopping and Resuming Status of DVD

With the DN-V310, when playing a DVD, when the stop operation is performed or the stop command is
issued for the first time, the DN-V310 changes to the resume mode, and when the stop operation is
performed or the stop command is issued for a second time, the DN-V310 changes to the stop mode.
The response to serial remote commands according to the device's status is defined as shown below.
The validity of commands depends on the device's status, so be careful when controlling by serial
remote.
PC control PC control PC control PC control
group group group group command command command command
PC PC PC PC
RC RC
RC RC
PlayT PlayT PlayT PlayT
PlayC PlayC PlayC PlayC
Time Time
Time Time
SetAST SetAST
SetAST SetAST
SetSPST SetSPST
SetSPST SetSPST
PS PS PS PS GetStatus GetStatus GetStatus GetStatus
GetDiscType GetDiscType GetDiscType GetDiscType
GetAST GetAST GetAST GetAST
GetSPST GetSPST
GetSPST GetSPST
GetT GetT
GetT GetT
GetC GetC GetC GetC
The DN-V310 is designed to issue the "PR StatusChange" message when a change of status occurs,
but the resume and stop modes are not distinguished, and both have the status code "3".
To switch to the stop mode by serial control when playing a DVD, issue the "STOP" command two times
by PC RC command.
Example: To switch to the stop mode while playing a DVD
[PC,RC,49]<CR>
[PC,RC,0]
[PR,StatusChange,3] ← The DN-V310 switches to the resume mode and a message is issued.
[PC,RC,49]<CR>
[PC,RC,0]
V310 response V310 response
V310 response V310 response
DVD STOP DVD STOP DVD STOP DVD STOP
Same as IR remote controler
・OK→Title Play
・NG→Error code2
・OK
→Title&Chapter
PLAY
・ChapNG→Error code2
・TitleNG→Error code2
・OK→Time Play
・NG→Error code2
Error code10
Error code10
Status ：3
Code：1
Error code1
Error code1
Error code1
Error code1
→ First stop message sent from the controller.
← The sent message's error code 0 (no error) is returned from the DN-V310.
→ Second stop message sent from the controller.
← The sent message's error code 0 (no error) is returned from the DN-V310.
The DN-V310 switches to the stop mode. (No message is issued.)
DVD RESUME DVD RESUME DVD RESUME DVD RESUME
Error code10
Error code10
Error code10
Error code10
Error code10
Status3
Code：1
Memorized No.
Memorized No.
Memorized No.
Memorized No.
２４