Error Codes; Command Reference - Denon DN-V310 Instructions Manual

Serial Remote Control (continued)
Send one command at a time.
Example: When playing a DVD, pause after playing Title 1.
[PC,PlayT,1]<CR>
[PC,PlayT,0]
[PC,RC,48]<CR>
[PC,RC,0]
[PR,StatusChange,0,5]

Error codes

If the structure of the command from the controller was wrong or the contents of the command were
invalid for any reason, a message consisting of an error code added to the sent command is returned.
List of error codes
Error code Name
0 No error
1 Cause of error not known
2 Invalid parameter
5 Command not valid
10 Command not valid for
Current disc
Example: When a command for starting to play Title 80 on a disc only including 20 titles was sent.
[PC,PlayT,80]<CR> → Command to play Title 80 sent from controller.
[PC,PlayT,2]

Command reference

Commands are combinations of two ASCII code characters.
The basic format of transmission commands is
Ⅰ. External Control Commands: List of PC group external control commands
Command name
1 Remote control command
2 Play Title or Track
3 Play Chapter
4 Time search
5 Set audio stream
6 Set sub-picture stream
7 SW on/off OSD display
8 SW on/off
Local keyboard Lock
9 SW on/off IR remote control
10 Set resolution
11 Standby on/off
→ Command to play Title 1 sent from controller.
← Reply of error code 0 (no error) from DN-V310.
→ Pause command sent from controller.
← Reply of error code 0 (no error) from DN-V310.
← Issue of status change (pause) message from DN-V310.
Description
Message received normally.
Error of unknown cause has arisen.
Invalid parameter received.
Invalid message structure detected.
Parameter outside of specified range received.
Message invalid for current disc type received.
← Error code 2 returned from DN-V310 and no response.
[group,command,parameterlist]<CR>
Command
RC Perform same command as for
infrared remote control operation.
PlayT Play assigned title or track number.
PlayC Play assigned chapter number.
Time Play starting at specified time.
SetAST Set the DVD audio stream number.
SetSPST Set the DVD sub-picture stream
number.
OSD Turn the OSD display on (displayed)
or off (not displayed).
LKC Turn the main unit front panel's lock
on (panel's key lock) or off (panel's
key available).
RCC Turn IR remote control on or off.
SetREZ
Set HDMI resolution.
Stby
６
Function
.
Parameter range
See list of PC RC
command control
parameters
0 to 99
Title : 1 to 99
Chapter : 1 to 999
H : 0 to 6
m : 0 to 59
s : 0 to 59
1 to 9
0 to 32
ON/OFF
ON/OFF
ON/OFF
0 to 4
0:/1