About The Remote Control; Loading The Batteries; Using A Remote Control; Remote Control - Denon DVD-1800BD Operating Instructions Manual

Introduction
About
the Remote Control
'
I
Using a Remote Control
Introduction
I
Changing the Signal Code of a Remote Control
• Change the signal code of the unit
1) In stop mode, press [SETUP].
2) Use
[<ll
[» to select
it
then press [ENTER).
3) Use
[<ll
[» to select. then press [ENTER).
4)
Use [.6
1
'V] to select "Remote Control5etting".
5) Press [ENTER] to select "DENON1" or "DENON2".
To avoid the other DENON's BD players responding the remote
signal of this unit, you can change the signal code of the remote
control. If the signal code ofthe remote control does not match to
the signal code of the unit, you cannot control the unit with the
remote control.
6)
Press [SETUP) to exit.
• At this point the new signal code of the unit is effective. Please
change the signal code of the remote control to match to the
signal code ofthe unit with following procedure.
• If the signal code does not match, the signal code of the remote
control will be displayed on the front panel display.
• The default setting and the setting after you change the
batteries is "DENONl
n
•
.Change the signal code ofthe remote control
Set to "DENON1":
Press and hold [RETURN], and press [3], [2], (1).
set to "DENON2":
Press and hold [RETURN], and press (1), (2), [3].
23 feet (7m) 30· 23 feet (7m) 23 feet (7m) 30·
Keep in mind the following when using the remote control:
• Make sure that there are no obstacles between the remote
control and infrared sensor window on the unit.
• Remote operation may become unreliable if strong sunlight or
fluorescent light is shining on infrared sensor window of the
unit.
• Remote control for different devices can interfere with each
other. Avoid using remote control for other equipment located
close to the unit.
• Replace the batteries when you notice a fall off in the operating
range of the remote control.
• The maximum operable ranges from the unit are as follows.
- Line of sight: approx. 23 feet (7m)
• Either side of the center: approx. 23 feet (7m) within 3D·
I
Setting this Unit not Reid to Other DENON's DW Playtr's Remote
Control
I
If you have other DENON's DVD players around this unit, this unit
reacts to the commands you made for DVD players through its
remote control. To avoid this situation, you can set this unit not
react to other DENON's DVD player's remote control.
1) In stop mode, press [SETUP]•
2) Press (7),[8),[9),[2].
3) Press [SETUP).
• ·Only Attached Remocon
n
will be displayed on the upper
right corner of the screen and this unit only react to the
commands from this unit's remote control.
• To set back to default, press (7),[8],[9),[1] at step 2. "Normal
Remocon
n
will be displayed on the upper right corner of the
screen and this unit react to both the commands from this unit's
remote control and the other DENON's DVD players' remote
control.
®
Insert two "AA
n
(R6P)
batteries, with each one
oriented correctly.
CD
Open the battery
compartment cover.
@
Close the cover.
CGutJons on,Btltteria
.:ljse'oAAo
(R6P)~Uenes
In this remotecontral•
•'Replace the batteric!S, with new ones approximately once a' ,
year, though this depe'!ds on
thefreq~
with which the
,;remQte contrails
used, ' , ' '"
""",.,~"
,. . , '
~]f
the remote contral does not operate within a dose
'. proximity of the mitin unit, replace
the
~tteries '!iittll\~'
,
Qnes,
evenlf
less than a year has passed.
" . n '
'~·the
InClUded bat!:erles
~rve
only forverlfylng ()perar
iRepiace them with neW batteries~s~as po$sible,
..en IflSel1ing'
tteries;\:)e~reful to ~o
5q;,
in
'the
Qperc;fire4io '. . . . fl9t.
"oI's\:lat!:e
.~rn!
o
preventda~geor'batterY
ea ge:
{DPnot
mix
a
neW
battery
wlth
an
Clidcme;' .". ".
. . . . • •
~.
Do
not mix twodlfferenttYPes ofbatteries
such
aSalj(aUne
•••• and
mangilnese~.·
"'.' . ' '.' . '
"'",Do
not short-circuit disassemble, heat
QI'
di$pOseQf
batteries inflames. ' ' ',' . " ,
•• Remove the batteries when notpJannlngto use
the
;femote
control for a long period
of
time.. " " . '
• If
the batteries should
leak,
carefully wipe off the fluid from
the inside
of
the battery compartment:, then
in~rt
new
batteries.
I
Loading the Batteries
6
ENGUSH