Denon DN-V310 Instructions Manual page 10

[PC,PlayC,0]
4. Time search command ( Time ) ---- Valid for DVDs
<Format> [PC,Time,hour,minute,second]<CR>
<Reply> [PC,Time,Error code] (For the error codes, refer to the list of error codes on page 6.)
<Details> ・In the stop, play and pause modes, playback starts from the specified time.
・If a time that does not exist on the disc is specified, error code 2 is returned.
・If a disc other than a DVD is loaded, error code 10 is returned and control is not
accepted.
・If the time is specified from the stop mode, the specified time in the main title is played.
・For discs on which there is no navigation data for the main title, the title with the
longest recording time is handled as the main title and played.
Example: To start playback from 0 hours, 50 minutes, 30 seconds
[PC,Time,0,50,30]<CR> → The command to start playback from the specified time is
[PC,Time,0]
5. Set audio stream setting command ( SetAST ) ---- Valid for DVDs
<Format> [PC,SetAST,Audio stream No.]<CR>
<Reply> [PC,SetAST,Error code] (For the error codes, refer to the list of error codes on page 6.)
<Details> ・In the play or pause mode on a DVD, sets the audio stream selection.
・If a stream number that does not exist on the disc is specified, error code 2 is returned.
・If a disc other than a DVD is loaded, error code 10 is returned and control is not
accepted.
・The set stream number is only valid within the currently playing title. If the title is
changed, the stream number is reset according to the navigation data of the newly
playing title. (If nothing is specified in the navigation data, the setting remains valid.)
Example: To set to audio stream 1
[PC,SetAST,1]<CR> → Audio stream 1 is sent from the controller.
[PC,SetAST,0]
← Error code 0 (no error) is returned from the DN-V310 and playback starts.
sent from the controller.
← Error code 0 (no error) is returned from the DN-V310 and
playback starts.
← Error code 0 (no error) is returned from the DN-V310 and the setting is made.
１０