Extreme Networks BlackDiamond 10808 Installation Manual page 95

8 Ensure that the module is vertical with the module name at the top, the PCB to the right, and that
the ejector/injector levers are extended, as shown in
9 Slide the module into the appropriate slot of the chassis until it makes contact with the backplane.
As the module begins to seat in the chassis, the ejector/injector levers begin to close.
10 Close the ejector/injector levers using both hands simultaneously to push the levers toward the
center of the module, as shown in
11 Secure the module by tightening the two captive screws using a #1 Phillips screwdriver.
12 Store the module packaging for future use.
To install additional I/O modules, repeat steps 3 through 12.
Figure
Injector/
Open ejector lever
Lock
Lock
Captive Injector/
Open
screws ejector lever
Figure 45.
45.
Open
Lock
Lock
Open
EX_017
95