Extreme Networks BlackDiamond 10808 Installation Manual page 43

Mini-GBICs are 3.3 V Class 1 laser devices. Use only Extreme-approved devices.
If you see an amber blinking mini-GBIC port status LED, the mini-GBIC installed in your switch or
module is not approved, supported, or certified by Extreme Networks. To correct this problem, install
an Extreme Networks-certified mini-GBIC.
To remove a mini-GBIC similar to the one labeled "Module A" in
the black plastic tab at the bottom of the connector to release the mini-GBIC, and pull the mini-GBIC
out of the SFP receptacle.
To remove a mini-GBIC connector similar to the one labeled "Module B" in
front handle and pull the mini-GBIC out of the SFP receptacle.
To insert a mini-GBIC connector:
1 Holding the mini-GBIC by its sides, insert the mini-GBIC into the SFP receptacle on the switch or
module.
2 Slide the mini-GBIC into the SFP receptacle until you hear an audible click, indicating the mini-GBIC
is securely seated into the SFP receptacle. If the mini-GBIC has a handle, push up on the handle to
secure the mini-GBIC.
This section describes installing and removing the XENPAK module, a 10 Gbps optical transceiver. You
can install or remove the XENPAK module from your Extreme Networks switch without powering off
the system. The module is shown in Figure 11.
Figure 10, gently press and hold down
Figure 10, gently rotate the
43