Extreme Networks BlackDiamond 10808 Installation Manual page 138

Follow these steps to ensure proper removal of the BlackDiamond 8810 fan tray from the BlackDiamond
8810 chassis:
1 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
chassis.
2 Locate the two captive screws on the top and bottom position of the fan tray.
3 Turn each captive screw counter-clockwise, using a #2 Phillips screwdriver, to loosen the captive
screws as shown in Figure
4 Pull the fan tray half-way out from the fan tray slot using the fan tray handle also shown in
Figure 79. This action disconnects the power from the chassis to the fan tray.
5 Slide the fan tray completely out from the fan tray slot by placing one hand on the fan tray handle
and the other hand guiding the bottom of the fan tray.
79.
Fan Tray
Captive
Screws (x2)
Fan Tray
Handle
ASP031A
138