Extreme Networks BlackDiamond 10808 Installation Manual page 139

Follow these steps to ensure proper installation of the BlackDiamond 8810 spare fan tray into the
BlackDiamond 8810 chassis:
1 Ensure that the fan tray slot on the chassis is empty.
2 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
chassis.
3 Align the spare fan tray with the fan tray slot on the chassis.
4 Lift the spare fan tray into the fan tray slot on the chassis by placing one hand on the fan tray handle
and the other hand guiding the bottom of the spare fan tray.
5 Gently slide the spare fan tray into the fan tray slot on the chassis using the fan tray handle as
shown in Figure 80.
6 Turn each captive screw clockwise, using a #2 Phillips screwdriver, to tighten the captive screws also
shown in Figure 80.
Fan Tray
Captive
Screws (x2)
Fan Tray
Handle
ASP030A
139