Extreme Networks BlackDiamond 10808 Installation Manual page 113

Follow these steps to ensure proper re-crating and re-packing for the BlackDiamond 8810 chassis:
1 Mount the 19" helper bracket into the system rack using four mount screws
2 Loosen the eight mount screws holding the chassis from the system rack using a #2 Phillips
screwdriver.
3 Using two people, place one hand in the empty power supply bay and the other hand in the rear
slot on the back panel of the chassis.
4 Slowly guide the chassis out from the system rack using the 19" helper bracket.
5 Gently lift the chassis off from the 19" helper bracket onto wood pallet as shown in Figure 58.
ASP017A
113