Extreme Networks BlackDiamond 10808 Installation Manual page 102

This section describes how to replace the BlackDiamond 10K series filter.
You need the following tools and equipment to install a fan tray:
# 2 Phillips screwdriver
Replacement filter
To replace the filter in the BlackDiamond 10K series switch:
1 Remove the bezel from the front of the chassis using a #2 Phillips screwdriver.
2 Slide the filter out from the chassis.
3 Slide a new filter into the chassis.
Use the directional arrows on the top side of the filter to ensure the filter is facing the correct way, as
shown in Figure 48.
Air filter
EX_081
102