Extreme Networks BlackDiamond 10808 Installation Manual page 135

Follow these steps to ensure proper removal of a BlackDiamond 8810 blank front panel:
1 Select a slot for removal of the blank front panel. Slots are numbered 1 through 10 in the chassis.
2 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
chassis.
3 Loosen both captive screws, located on each end of the blank front panel, using a #2 Phillips
screwdriver as shown in Figure 77.
ASP018
ASP019
135