Adding Filters - ATEN RCM101A User Manual

RCM101A User Manual

Adding Filters

To add an IP filter, do the following:
1. Click Add. A dialog box similar to the one below appears:
2. Key the address you want to filter in the From: field.
 To filter a single IP address, key the same address in the To: field.
 To filter a continuous range of addresses, key in the end number of the
range in the To: field.
3. After filling in the address, click OK.
4. Repeat these steps for any additional IP addresses you want to filter.
To add a MAC filter, do the following:
1. Click Add. A dialog box similar to the one below appears:
2. Specify the MAC address in the dialog box, then click OK.
3. Repeat these steps for any additional MAC addresses you want to filter.
 IP Filter / MAC Filter Conflict
If there is a conflict between an IP filter and a MAC filter – for example, where
a computer's IP address is allowed by the IP filter but it's MAC address is
excluded by the MAC filter – then that computer's access is blocked.
In other word's, if either filter blocks a computer, then the computer is blocked,
no matter what the other filter is set to.
52