Advertisement
Quick Links
Advertisement
Related Manuals for ATEN CS-104
Summary of Contents for ATEN CS-104
-
Page 2: Packaging Checklist
Foot Switch (Optional) Troubleshooting Preventing Radio & TV Interference Limited Warranty Packaging Checklist: Master View CPU Switch [CS-104] Power Adapter [DC 9V 250mA CPU Switch User’s Manual [This Book] ©Copyright 1996 ATEN® International Co., Ltd. Manual Part No. PAPE-0126-200 (minimum) - Page 3 Master View is a controller for that will allow one user to access multiple computers. Before, the costly network was the only solution for this application. Now, the Master View provides the easiest and the most cost-effective way of accessing multiple computers. With the powerful features of Master View, anyone is capable of operating or testing many computers with one of each, a monitor, a keyboard and a mouse.
- Page 4 One Stage: In a one-stage system, a single CS-104 can control up to four computers. The DIP switch #4 is set to the ON position. Connect the monitor output, mouse port, and the keyboard port of a computer to one of the CS-104’s available PC port groups with the appropriate cables.
- Page 5 (second stage units) or a combination of both. In this configuration the maximum number of computers that can be in the system is 16. The DIP switch #4 on the first stage unit (The CS-104 directly connected to the monitor, mouse, and keyboard) is placed in the ON position. All other CS-104 units have DIP switch #4 in the OFF position.
- Page 6 64. The DIP switch #4 on the first stage unit (The CS-104 directly connected to the monitor, mouse, and keyboard) is placed in the ON position. All other CS-104 units have DIP switch #4 in the OFF posi- tion.
-
Page 7: Hardware Installation
For a computer in the second stage of a Two-Stage system you will have to make your selection on the CS-104 unit directly connected to the PC you wish to use. Similarly in a Three-Stage system you will need to make your selection on the CS-104 unit directly connected to the computer in the third stage. - Page 8 then enter the command keystrokes and complete the command by hitting the [Enter] key. To start the Auto-Scan mode: (This mode scans all connected computers that are in a power on state, one- by-one, from the first computer in the first stage, to the last computer in the last stage) [Alt] [Ctrl] [Shift] + [0] + [Enter] To stop Auto-Scan mode: [Space]...
- Page 9 If a port is not selected, its corresponding PORT STATUS LED will be off. If a port is selected that is connected to another CS-104, its corresponding PORT STATUS LED will flash: If a port is selected that is connected to a “power-on” computer, its corresponding PORT STATUS LED will remain lit.
- Page 10 Foot Switch part # CONNECTION The Foot Switch is connected to the CS-104 through a RJ-11 phone jack which is located on one side of the unit. If you plan to install an ON/OFF switch to work with the Push Button, check the diagram to the right to ensure correct switch connection.
- Page 11 Symptom The first-stage CS-104 unit will not take Hot Key commands. Pressing the Hot Keys get no response. Mouse is not responding or be- ing detected The CS-104 does not work properly. Possible Causes What to do Incorrect DIP switch Set the first-stage settings .
- Page 12 WARNING!!! This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. This equipment has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interfer- ence when operated in a commercial environment.