Working Mode - ATEN RCM101A User Manual

RCM101A User Manual

Working Mode

Use this section to set the working mode parameters.
 Enable ICMP so that the RCM101A can be pinged. If it is not enabled, the
device cannot be pinged. The default is Enabled.
 Enable Multiuser Operation to permit more than one user to log into the
RCM101A at the same time. The default is Enabled.
 Enable Virtual Media Write allows redirected virtual media devices on a
user's system to send data to a remote server, as well as being able to have
data from the remote server written to them. The default is Enabled.
 Browser Service allows the administrator to limit the scope of browser
access to the RCM101A. Put a check in the checkbox to enable this
function, then select the browser limitation in the drop down list box.
Choices are explained in the following table:
Item
Disable Browser
Disable HTTP
Disable HTTPS (SSL)
 If Disable Authentication is checked, no authentication procedures are
used to check users attempting to log in. Users gain Administrator access
to the RCM101A switch simply by entering combination of username and
password.
Note: Enabling this setting creates an extremely dangerous result as far as
security goes, and should only be used under very special
circumstances.
56
If this is selected, the RCM101A cannot be accessed
via a browser. It can only be accessed from the
Windows Client.
If this is selected, the RCM101A can be accessed via a
browser, but not from an ordinary (HTTP) login
connection – it can only be accessed over a secure
HTTPS (SSL) connection.
If this is selected, the RCM101A can be accessed via a
browser over an ordinary (HTTP) login connection, but
not via a secure HTTPS (SSL) connection.
Explanation