Advertisement
KEY OPERATOR PROGRAMS
P10 Auditing Mode
Program P10 is used to enable or disable the basic auditing mode of
operation.
When disabled, the message in the display will be "READY TO
COPY." Access to copying is open to any operator.
When enabled, the message in the display will be "ENTER YOUR
ACCOUNT NUMBER -----." Copying in this state is limited to oper-
ators with an assigned 5-digit account number.
A maximum of 500, 5-digit account numbers can be assigned. Use
Key Operator Program P14 to assign account numbers.
P11 Copies by Account
Program P11 is used to display or print the total number of copies
made against each account number. For printing the data, an option-
al counter commander SF-EA13 is needed. (See page 23 for instruc-
tions to print.)
When P11 is entered, the following message will appear.
6
Downloaded from:
http://www.usersmanualguide.com/
I
I
<P009>
P11: COPIES BY ACCOUNT.
1.PRINT
To print accounts
1.
Press key 1.
The following message will appear.
<P010>
PRINT:
1.ALL ACCOUNTS.
2.SINGLE ACCOUNT.
2.
To print all accounts, press key 1.
To print a single account, press key 2, enter the
account number, and press the START key.
3.
Press the START/STOP key of the counter commander.
To sequentially display accounts
1
Press key 2.
2.
Press the SCROLL DISPLAY key to advance through
the accounts.
The account numbers and the number of copies made against
each account will be sequentially displayed.
3.
Press the PROGRAM key to exit the program.
2.DISPLAY(SINGLE)
Advertisement
