Using The Key Operator Programs - Sharp SD-2060 Key Operator's Manual

AUDIT
0 /
CLEAR
1
4
7
0 /
COPIES SELECTED
PROGRAM
P
CLEAR ALL
CA
INTERRUPT
Downloaded from: http://www.usersmanualguide.com/
CLEAR/STOP
C /
INTERRUPT
3
2
5
6
8
9
CLEAR/STOP
AUDIT
CLEAR
1
4
7
I I

Using the Key Operator Programs

Press the CLEAR/STOP key, the INTERRUPT key, and
1
the CLEAR/STOP key again.
The following message will appear.
<P006>
ENTER KEY OPERATOR CODE.
Enter the key operator code number.
2
The dashes on the message will change to asterisks. If the
entered code number is correct, "P" will appear on the COPIES
SELECTED display.
3 Enter the desired 2-digit program code number and
press the START key.
If a mistake is made during entry, press the CLEAR/STOP key
to clear the entry.
The message display will show the number and name of the
program.
In some programs, the current setting will be displayed on the
COPIES MADE display and highlighted in the message dis-
play.
Follow instructions for the program.
4
When all steps for the program have been completed or when
the PROGRAM key is pressed to exit the program, "P" will ap-
pear on the COPIES SELECTED display so that another pro-
gram can be selected.
To exit the key operator program mode, press the
5
CLEAR ALL key.
KEY OPERATOR PROGRAMS
–––––
5