Sharp SD-2060 Key Operator's Manual page 18

KEY OPERATOR PROGRAMS
P25 Limit of Maximum Copies Selected
Use P25 to limit the maximum number of copies per copy run which
can be input on the COPIES SELECTED display.
When P25 is entered, the following message will appear.
P26 Initial Margin Shift Setting
Set the initial margin shift value with this program.
When P26 is entered, the following message will appear.
P27 Erase Width Adjustment
Set the initial amount of the erase area with this program.
When P27 is entered, the following message will appear.
16
Downloaded from: http://www.usersmanualguide.com/
I I
<P045>
P25: LIMIT OF MAXIMUM COPIES SELECTED.
ENTER THE NUMBER AND PRESS START.
Input the number using the 10-key pad and press the
START key.
<P047>
P26: INITIAL MARGIN SHIFT SETTING.
Select the desired values for front and back sides using the
10-key pad.
<P048>
P27: ERASE WIDTH ADJUSTMENT.
FOR EDGE ERASE MODE.
1. 0—6mm 2. 6—12mm
1. Make the selection for edge erase using the 10-key
pad.
The following message will appear.
<P049>
FOR CENTER ERASE MODE.
1. 10mm 2. 15mm
2. Make the selection for centre erase using the 10-key
pad.
SIDE 1 SIDE
AMOUNT PUSH AMOUNT PUSH
0 1 0
3mm 2 3mm
6mm 3 6mm
9mm 4 9mm
12mm 5 12mm
15mm 6 15mm
3. 12—18mm
3. 20mm
999
2
1
2
3
4
5
6