Advertisement
P28 Initial Status Setting
The copier will assume the initial settings when it is turned on, when
the CLEAR ALL key is pressed, or when the auto clear interval has
elapsed after a copy run. Use P28 to establish the initial settings.
When P28 is entered, the following message will appear.
P29 Total Copy Count
Program P29 is used to display or print the total copy counts of the
copier, RADF, duplex module, and staple sorter.
For printing the data, an optional counter commander SF-EA13 is
needed. (See page 23 for instructions to print.)
When P29 is entered, the following message will appear.
Downloaded from:
http://www.usersmanualguide.com/
I
I
<P050>
P28: INITIAL STATUS SETTING.
PROGRAM DESIRED INITIAL STATUS AND
PRESS START.
To establish new initial settings
1.
Make all initial selections on the operation panel.
The following functions can be set: original to copy mode, re-
duction/enlargement/zoom, exposure adjustments, erase,
margin shift, tray select, and sort/staple sort mode (only if an
optional sorter or staple sorter is installed).
2.
Press the START key.
To return to the factory set initial settings
1.
Press the CLEAR/STOP key.
2.
Press the START key.
<P051>
P29: TOTAL COPY COUNT.
1.DISPLAY
To display total copy counts
Press key 1.
The following message will appear.
<P052A>
COPIES:
DOCUMENT FEEDER: --------
DUPLEX:
STAPLER:
To print total copy counts
1.
Press key 2.
The following message will appear.
<P011>
PUSH THE START/STOP KEY ON THE SF-EA13.
2.
Press the START/STOP key of the counter commander.
KEY OPERATOR PROGRAMS
2.PRINT
--------
--------
--------
17
Advertisement
