The Printer Does Not Print (Ready Light Off); The Ready Light Is On But Nothing Prints - Epson EPL-N3000 Reference Manual

The printer does not print (Ready light off)

Cause
The printer is offline.

The Ready light is on but nothing prints

Cause
Your computer may not be
properly connected to the
printer.
The interface cable may not be
plugged in securely.
You may not be using the
correct interface cable.
Some error may have
occurred.
Your application software is
not properly set up for your
printer.
262
Troubleshooting
What to do
Press the N Start/Stop button once to
switch the printer to ready status.
What to do
Perform the procedure described in
"Connecting the Printer to a Computer"
in the Setup Guidesetup guide.
Check both ends of the interface cable
between the printer and the computer.
If you are using the parallel interface, be
sure to secure the connector using the
wire retaining clips.
If you are using the parallel interface,
make sure that the cable is a
double-shielded, twisted-pair interface
cable no more than six feet in length.
If you are using the USB interface, use a
Revision 1.1 or 2.0 cable.
Check the LCD panel to see if an error
message appears.
Make sure that the printer is selected in
your application software.