Emptying The Ash Boxes - Viessmann Vitoligno 300-C Installation And Service Instructions For Contractors

Emptying the ash boxes

Note
If the ash box is being emptied without a message
having been displayed on the control unit, reset the
ash fill level at the control unit:
for "Extended menu"
data" Select "Ash box"
"Yes"-"No" d to confirm.
C
E
Fig. 29
1. Shut down the boiler.
2. Remove front panel
A
3. Open tensioning toggles
the tension toggle clip.
4. Pull out locking pins
C
the back as far as it will go.
5. Push ash box slightly to the left and then pull it
E
out towards the front.
"Information" "Reset
"Reset data"
D
B
from the boiler.
by pushing down on
B
. Push ash separator to
D
Commissioning, inspection, maintenance
Danger
Breathing in ash or pellet dust is detrimental to
health.
Wear a dust mask to protect your respiratory
tract.
A
6. Empty the ash box. For this, remove the cover from
the ash box.
7. Clean the interior of the boiler from ash residues.
8. Proceed in reverse order to re-insert the ash box
and close the boiler.
Note
Before closing the boiler, ash separator
be opened again.
9. Switch the boiler ON again.
has to
D
39