Using The Reset Button; Reset Button - Enterasys SecureStack C2 C2G124-48P Hardware Installation Manual

Using the Reset Button

Table 4-2 Troubleshooting Checklist (continued)
Problem
Port(s) goes into
standby for no
apparent reason.
User parameters
(IP address, device
and module name,
etc.) were lost
when the switch
power was cycled.
Using the Reset Button
If you forget the switch login password, use the Reset button as described in the following
procedure.
Figure 4-3

1 Reset button

4-8 Troubleshooting
Possible Cause
Loop condition detected.
Clear NVRAM was set using
CLI commands.
Reset Button
Recommended Action
Verify that Spanning Tree is enabled. Refer to the
SecureStack C2 Configuration Guide for the instructions to
set the type of STA.
Review the network design and delete unnecessary loops.
If the problem continues, contact Enterasys Networks for
technical support.
Reenter the lost parameters as necessary. Refer to the
SecureStack C2 Configuration Guide for the instructions to
configure the switch using CLI commands.
If the problem continues, contact Enterasys Networks for
technical support.
À