Table of Contents
Advertisement
This chapter introduces the C2G124-48P and C2H124-48P Gigabit Ethernet stackable
switches.
Depending on the firmware version used in the switch, some features described in this document
may not be supported. Refer to the Release Notes shipped with the switch to determine which
features are supported.
For information about...
Overview
The C2G124-48P and C2H124-48P are stackable switches that can be adapted and scaled
to help meet your network requirements. These switches provide a management platform
and an uplink to a network backbone for a stacked group of up to eight C2 switches.
The switches also support the use of a redundant DC power supply to help prevent
downtime due to an internal power supply failure in the switch or AC power source.
You can install the switch on a flat surface or into a standard 19-inch rack with user-
supplied mounting hardware, and configure the switch functions using the WebView™
application, CLI switching commands, and/or SNMP.
Important Notice
Introduction
Refer to page...
1-1
1-5
1-6
1-6
1-7
1-7
1-7
SecureStack C2 Installation Guide 1-1
1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
