Using Lanview; C2G124-48P Lanview Leds - Enterasys SecureStack C2 C2G124-48P Hardware Installation Manual

Using LANVIEW

Using LANVIEW
The switch uses the Enterasys Networks built‐in visual diagnostic and status monitoring
system called LANVIEW. For the location of LANVIEW LEDs on the C2G124‐48P and
C2H124‐48P, refer to Figure 4‐1 and Figure
quickly observe network status for diagnosing switch and network problems.
Figure 4-1
1 CPU LED
2 STACK DOWN LED
3 STACK UP LED
4 RPS LED for redundant power
source status
5 Manager LED
1. These Mini-GBIC ports will only establish a link when the RJ45 port equivalent is not linked on a
4-2 Troubleshooting
C2G124-48P LANVIEW LEDs
Å
C2G124-48P. (For example: when Mini-GBIC port 45 is linked, RJ45 port 45 is deactivated. When
Mini-GBIC is not linked, the RJ45 port 45 is reactivated and can establish a link as long as the
Mini-GBIC port 45 is not linked first.)
4‐2, respectively. These LEDs allow you to
Ä
Ã
Â
Á
À
6 Link/Activity/PoE LED for 10/100/1000 Mbps, RJ45 port 1
7 Link/Activity/PoE LEDs for 10/100/1000 Mbps
RJ45 ports 45 through 48
8 Link/Activity LEDs for 1-Gbps Mini-GBIC ports 49 through
1
52
Æ Ç