Enterasys 2H25x User Manual page 55

Table 3-4 Radius Configuration Screen Field Descriptions (Continued)
Use this field...
Auth Port
(Modifiable)
Acct Port
(Modifiable)
Timeout
(Modifiable)
Retries
(Modifiable)
Last Resort
Action/Local
(Selectable)
Last Resort
Action/Remote
(Toggle)
Radius Client
(Toggle)
To...
Enter the number of the Authorization UDP Port for the Primary and
Secondary server.
Enter the number of the Accounting UDP Port for the Primary and
Secondary server.
Enter the maximum time in seconds to establish contact with the
Radius Server before timing out.
Enter the maximum number of attempts (1...N) to contact the Radius
Server before timing out.
Accept, Challenge, and Reject, which do the following:
ACCEPT: Allows local access (via COM port) at the super-user
level with no further attempt at authentication.
CHALLENGE: Reverts to local module (legacy) passwords.
REJECT: Does not allow local access.
For more details, refer to
To set local and remote servers, refer to
Accept, Challenge, and Reject, which do the following:
ACCEPT: Allows remote access (via Telnet or WebWiew) at the
super-user level with no further attempt at authentication.
CHALLENGE: Reverts to local module (legacy) passwords.
REJECT: Does not allow remote access.
For more details, refer to
To set local and remote servers, refer to
Enable or disable client status.
RADIUS Configuration Screen
Section 3.7.1.
Section
Section 3.7.1.
Section
Accessing Local Management
3.7.2.
3.7.2.
3-19