Enterasys 2H25x User Manual page 257

dynamic_egress (Continued)
Example: -> dynamic_egress status 1
Dynamic Egress Disabled for VLAN ID 0x0001
-> dynamic_egress enable 1
Dynamic Egress Enabled for VLAN ID 0x0001
-> dynamic_egress disable 1
Dynamic Egress Disabled for VLAN ID 0x0001
radius
Description: Used to enable, disable, and configure the radius function. Radius
authentication is only used when the client has been properly configured and
enabled. When the Radius Client is not enabled, the legacy password
authentication will run as before. For more about Radius Client, refer to
Section
Syntax: radius
radius status
radius [enable | disable]
radius prim_ip <server ip>
radius sec_ip <server ip>
radius timeout <n>
radius retry <n>
radius clear
radius prim_auth_port <n>
radius sec_auth_port <n>
radius prim_acct_port <n>
radius sec_acct_port <n>
radius last_resort < [local|remote] [accept|reject|challenge] >
radius prim_secret
radius sec_secret
3.4.1.
Built-in Commands
Network Tools Screens 11-21