Table of Contents
Advertisement
Built-in Commands
vrrpPort (Continued)
Options:
get – displays a list of all port numbers of VRRP Ports currently set.
set port# – sets a specific port as a VRRP Port.
set all – sets all front panel as VRRP Ports.
unset port# – terminates the VRRP setting on a specific port.
unset all – terminates the VRRP setting on all front panel ports.
Example:
-> vrrpPort get
VRRP Port is set to 0.
-> vrrpPort set 1
VRRP Port is set to 1.
stpStandby
Description:
during link state change. The user may enable, disable, or see the status of the
stpStandby. The enable command causes the STP to go through the standby
states for the port that received a valid link. The disable command causes the
STP to stay in the forwarding state regardless of the link state change.
Syntax:
stpStandby [enable/disable/status]
Options:
11-16
Network Tools Screens
NOTE: Setting the VRRP Port(s) to 0 will disable this application.
Allows the user to control the behavior of the Spanning Tree Protocol (STP)
None
Advertisement
Table of Contents
