More About Rate Limiting - Enterasys 2H25x User Manual

Changing One or More Line Items
To change the configuration values in a line item, that line item must be deleted and replaced with
a new entry with the correct configuration values. The new settings can then be configured and
added.
Deleting All Line Items
To delete all configured line items, use the arrow keys to highlight the DEL ALL command field
and press ENTER.
Deleting One or More Line Items
To delete one or more line items, mark each entry and then delete them, as follows:
1. Use the arrow keys to highlight a line to be deleted.
2. Press the M key and an asterisk (*) appears next to the highlighted line to mark it. The DEL ALL
command is changed to DEL MARKED.
3. If more than one line item is to be deleted, repeat
NOTE: To remove a mark, perform
pressing M will remove the mark. If all marks are removed, the DEL MARKED command
is changed back to DEL ALL
4. After the lines are marked, use the arrow keys to highlight the DEL MARKED command field.
5. Press ENTER. The marked line items are deleted and the DEL MARKED command is changed
back to DEL ALL.

6.10.3 More About Rate Limiting

Rate Limiting enables Service Providers in Multi-Dwelling-Unit (MDU) and similar environments
to offer varied bandwidth to customers using low cost Ethernet connections. Another solution, for
the enterprise, is to provide high priority bandwidth on the network for guaranteed service level
agreements.
NOTE: When allocating the maximum rate per port, the maximum bandwidth of the
uplink must be kept in mind. For example, if the ports are all set to 10 Mbps and there
are 24 ports, this equals 240 Mbps of bandwidth. If the uplink is only 100 Mbps, there is
an obvious problem if the network administrator guaranteed more bandwidth than the
uplink can support.
steps 1
steps 1 and 2. When a marked line is highlighted,
.
802.1 Configuration Menu Screens
Rate Limiting Configuration Screen
and 2 to mark each line.
6-49