Sony KF-60XBR800 Manual page 5

Service Menu (All of these settings are only available in the service menu)
To change a data item for an input you must press [TV/Video] on the remote to
select that input while you are on the data item if you are not on that input and in
the proper mode [PRO, VIVID] with an image from that device on the screen.
Once you have changed the proper data item you must save it before proceeding
to the next input or mode or the change will be lost. Note: Sometimes an input
will change its signal type (720p to 480i) from a device without your asking it to
so make sure your changes took.
The following list is only a small subset of the values in the service menu. Go to
the correct category first and then move up to the correct item name to change a
value. Most of the values can be tested correctly without saving them. Only
store a value when you are sure of the change because going back requires you
to enter the original value manually.
THE FOLLOWING CHANGES ARE INTENDED FOR PRO MODE. MORE
CHANGES ARE REQUIRED IF YOU WISH TO MAKE VIVID, STANDARD OR
MILD MODE LIKE PRO.
ALWAYS RECORD THE CATEGORY, ITEM NO., DATA, PICTURE MODE,
ITEM NAME & INPUT SIGNAL BEFORE CHANGING ANYTHING!!!!
The service menu is arranged as
Category.....................Item No. ..............Data................Menu Mode
Item Name.................................................................Input Signal
The following are the service menu commands (multiple button pushes are
separated with a dash):
To Enter Service Menu
To Save Settings
To Navigate Service Menu
Up Item
Down Item
Up Category
Down Category
Increment Data
Decrement Data
Erase Changes That
Have Not Been Saved
To exit the Service Menu
follows:
Display - 5 - Vol+ - Power (While off)
Unplug TV after cooling down
Turn off the TV wait 3 or 4 minutes and
turn it back on or hit the power button
again after turning it off (very quickly).
4 of 12
Mute - Enter
1
4
2
5
3
6