Electromagnetic Compatibility (Emc) - GE SENOGRAPHE DMR+ Technical Publications

GE Medical Systems
REV1

ELECTROMAGNETIC COMPATIBILITY (EMC)

This equipment complies with IEC60601–1–2 Edition 2 EMC standard for medical
devices.
This equipment generates, uses, and can radiate radio frequency energy. The equipment
may cause radio frequency interference to other medical and non-medical devices and
radio communications. To provide reasonable protection against such interference, this
product complies with radiated emissions as per CISPR11 Group 1, Class A standard limits.
Detailed requirements and recommendations about power supply distribution and
installation are listed in the Pre–Installation Manual (pim) shipped with your system.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment is found to cause interference (which may be determined by turning the
equipment on and off), the user (or qualified service personnel) should attempt to correct
the problem by one or more of the following measure(s):
– reorient or relocate the affected device(s)
– increase the separation between the equipment and the affected device
– power the equipment from a source different from that of the affected device
– consult the point of purchase or service representative for further suggestions
The manufacturer is not responsible for any interference caused by using other than
recommended interconnect cables or by unauthorized changes or modifications to this
equipment. Unauthorized changes or modifications could void the users' authority to
operate the equipment.
All interconnect cables to peripheral devices must be shielded and properly grounded. Use
of cables not properly shielded and grounded may result in the equipment causing radio
frequency interference.
Do not use devices which intentionally transmit RF Signals (Cellular Phones, Transceivers,
or Radio Controlled Products) in the vicinity of this equipment as it may cause performance
outside the published specifications. Recommended separation distances are detailed in
the Pre–Installation Manual (pim) shipped with your system. Keep the power to this type of
devices turned off when near this equipment.
The medical staff in charge of this equipment is required to instruct technicians, patients,
and other people who may be around this equipment to comply fully with the above
requirement.
Further data and recommendations for meeting Electromagnetic Compatibility
requirements for a typical installation are given in the Pre–Installation Manual (pim)
shipped with your system. Note that the magnetic field of an MRI device located nearby
may cause a risk of interference. Magnetic field amplitude limits are specified in the
Pre–Installation Manual (pim) shipped with your system.
vi
SENOGRAPHE DMR+
om 5128689-2-100