GE SENOGRAPHE DMR+ Technical Publications page 71

GE Medical Systems
REV1
Message Message on
No. Column Readout
E 12 None
E 13 None
E 14 None
E 15 None
E 50 FAILURE
E 51 COLLIM FAIL
E 53 COLLIM FAIL
E 54 FAILURE
E 55 HOUSING FAIL
Message on
Control Console
CHECKSUM ERROR
(GEN)
GEN/ARM
COMMUNICATION FAIL
GEN/CPU FAILURE
CONSOLE
COMMUNICATION FAIL
SOFTWARE FAILURE
LATERAL COLLIMATOR
FAILURE
REAR COLLIMATOR
FAILURE
HARDWARE FAILURE
HOUSING ANGULATION
FAILURE
3-11
Explanation/meaning
of message
Calibration parameters have
been modified.
Generator cannot dialog
with arm.
CPU Board of generator is
faulty.
Generator cannot dialog with
Control Console.
Gantry software error
Lateral collimator is faulty, so
a good format cannot be
ensured.
Exposure is inhibited.
Rear collimator is faulty, so a
good format cannot be
ensured.
Exposure is inhibited.
Electronics fault in Gantry.
Tube housing angular shift is
faulty. Housing angular shift
is faulty.
Exposure is inhibited.
SENOGRAPHE DMR+
om 5128689-2-100
Corrective Action
1. Switch OFF.
2. Switch ON.
3. If fault continues, note ALL
messages and inform
GEMS Field Service.
1. Switch OFF.
2. Switch ON.
3. If fault continues, note ALL
messages and inform
GEMS Field Service.
1. Switch OFF.
2. Switch ON.
3. If fault continues, note ALL
messages and inform
GEMS Field Service.
1. Switch OFF.
2. Switch ON.
3. If fault continues, note ALL
messages and inform
GEMS Field Service.
Switch OFF and ON. If fault
continues, note all messages and
error codes (ESPECIALLY THE 6
DIGITS OF E50 MESSAGES) and
inform GEMS Field Service.
1. Switch OFF.
2. Switch ON.
3. If fault continues, note ALL
messages and inform
GEMS Field Service.
1. Switch OFF.
2. Switch ON.
3. If fault continues, note ALL
messages and inform
GEMS Field Service.
1. Switch OFF.
2. Switch ON.
3. If fault continues, note ALL
messages and inform
GEMS Field Service.
1. Switch OFF.
2. Switch ON.
3. If fault continues, note ALL
messages and inform
GEMS Field Service.