Adjusting Spindle Height; Fence Adjustments - Grizzly G0510ZW Owner's Manual

Adjusting Spindle
Height
The spindle height is adjustable to allow for preci-
sion positioning of cutter/bit exposure from the
table surface.
After making adjustments, it is extremely impor-
tant to always lock the spindle in place before
operating the shaper. Otherwise, the spindle posi-
tion can easily shift, causing inconsistent cutting
results from workpiece to workpiece.
To adjust cutter height:
1.
Loosen spindle elevation lock shown in
Figure 21.
Figure 21. Spindle elevation lock knob.
2.
Move spindle up or down with elevation
adjustment lever, shown in Figure 22, until
desired spindle height is obtained.
Figure 22. Spindle elevation adjustment lever.
3.
Lock spindle into position with lock knob.
-24-
Spindle
Elevation
Lock
Elevation Adjustment
Lever

Fence Adjustments

Each side of the fence is independently adjust-
able to compensate for different cutting thickness-
es and special shaping applications. One turn of
the fence offset knob (see Figure 23) moves the
split fence approximately
When removing material from the whole face
of your workpiece, the outfeed fence should be
adjusted to the proper offset to provide support for
the workpiece as it passes over the cutter.
To adjust fence for straight shaping:
1. Loosen fence lock lever (see Figure 23).
Fence Offset
Lock Lever
Figure 23. Example of fence adjustments.
2.
Adjust infeed fence so cutter will remove
desired amount of stock.
Note: To help determine the best setting,
select wood for a test piece that most closely
resembles your actual workpiece.
3. Lock infeed fence with fence lock lever.
Model G0510ZW (Mfd. Since 9/16)
/ " (.040").
3
64
Fence Offset
Knob