Table of Contents
Advertisement
Installing Cutters
Large cutters (3
⁄
" or greater) must be operated
1
2
at 5,000 or 7,000 RPM; smaller cutters can be
operated at 10,000 RPM. Cutters are advertised
with and should not exceed their rated RPM.
Always use the largest spindle size possible, and
never use a cutter bore more than one size larger
than the spindle size.
Tools Needed:
Spindle Wrench 50mm ...................................... 1
Hex Wrench 8mm .............................................. 1
To install a cutter:
1.
DISCONNECT MACHINE FROM POWER!
2.
Raise safety guard out of the way and raise
spindle to maximum height.
3.
Remove spindle cap screw and remove any
unneeded spacers.
4.
Place the cutter on the spindle. Make sure
the rotation is correct for your application.
5.
Use spacers to suit your particular application.
6.
Place the corresponding spindle two-piece
keyed washer above the cutter and spacers
and tighten the cap screw (see Figure 26).
Cap Screw
Spacers
Figure 26. Cutter and fasteners installed.
-26-
7.
Qty
8.
To adjust cutter height:
1.
Keyed
Washer Set
Cutter
2.
Tighten cap screw with hex wrench while
holding spindle stationary with spindle wrench
(see Figure 27).
Figure 27. Tightening spindle cap screw.
Replace safety guard and lower spindle to
desired height.
Adjusting
Spindle Height
Move spindle up or down with elevation
handwheel until desired position is achieved
(see Figure 28).
Figure 28. Spindle elevation handwheel.
Return spindle elevation to 0" by pressing
zeroing button on control panel.
Model G0900 (Mfd. Since 03/20)
Advertisement
Table of Contents
