Preparing Spindle For Test Run - Grizzly G0510ZW Owner's Manual

Preparing Spindle
for Test Run
To ensure your safety during the test run, make
sure the spindle nut and rub collars are tight,
or just completely remove the spindle nut and
rub collars. If these items are loose during the
Test Run, they could fly off and strike operator or
bystanders with great force.
To prepare spindle for test run:
1.
Remove (2) hex bolts and pulley guard, as
shown in Figure 16, to access drawbar nut.
Pulley
Guard
Hex
Bolt
Figure 16. Location of pulley guard.
Model G0510ZW (Mfd. Since 9/16)
2. Verify spindle and spindle nut are tight, as
shown in Figure 17 .
Note: If removing spindle nut, only hold
spindle at spindle flats to keep spindle from
rotating. Do not hold spindle at drawbar nut
when removing spindle nut, as this could
loosen drawbar nut.
3.
Re-install pulley guard.
Spindle
Flats
Drawbar
Nut
Hex
Bolt
Figure 17. Ensuring spindle is tight.
Spindle
Nut
Rub
Collars
-19-