Table of Contents
Advertisement
Adjusting Profile
Roller Height
To produce an accurate notch, the center of the
profile roller must be even with the center of the
tube when mounted in the vise (see Figure 45).
Cap Screws
Figure 45. Profile roller and tube even with each
other.
The correct height of the profile roller depends
on the height of the roller support bracket. This
was set properly at the factory. However, if you
determine that the center of the profile roller is not
even with the center of the tube when mounted
in the vise, perform the following procedure to
adjust it.
Items Needed
Hex Wrench 8mm .............................................. 1
To adjust roller support bracket height:
1.
DISCONNECT MACHINE FROM POWER!
2.
Properly mount tube in vise.
3.
Loosen roller support bracket cap screws
(see Figure 45).
4.
Move profile roller up or down to center
profile roller with center of tube.
5.
Retighten cap screws loosened in Step 3.
-36-
Roller Support
Bracket
Qty
Emptying Spark Trap
EXPLOSION OR FIRE HAZARD
ALWAYS empty spark trap and clean
machine
thoroughly
workpiece metal types. DO NOT allow dust
from different metal types to mix in spark
trap and on machine.
Wear ANSI-approved safety goggles, a
NIOSH-approved respirator, and leather
gloves when emptying spark trap. Minimize
amount of dust allowed to become airborne,
and prevent spread of dust onto clothing.
Dispose of all waste properly according to
local regulations for material type.
Empty spark trap contents daily or before switch-
ing to a new material type. Do not allow dust from
different material types to mix. Dust particles can,
depending on material type and circumstances
react and ignite. Dispose of waste according to
local regulations for material type.
The spark trap slides into grooves on the right
side of the machine (see Figure 46).
Spark Trap
Figure 46. Spark trap positioned in grooves.
Model G0767Z (Mfd. Since 11/17)
before
switching
Grooves
Advertisement
Table of Contents
