Spindle Height
To adjust the cutter height:
1.
2.
3.
Figure 29.
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
NOTICE
The lock knob keeps the spindle in a fixed
position during shaper operation. Do not
over-tighten the lock knob. A snug fit is
all that is needed to keep the spindle from
moving during shaper use.
Figure 29.
If removing material from the whole face,
observe the following steps:
1.
30
Figure 30.
2.
3.
Straight Shaping
Read the entire manu-
al before making any
cuts with your shaper.
Serious personal injury
may result if safety or
operational information
is not understood or fol-
lowed.
Figure