Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0510ZW (Mfd. Since 9/16)
manual
BEFORE
To complete a typical shaping operation, the
operator does the following:
1.
Examines workpiece to make sure it is suit-
able for shaping.
2.
Chooses, installs, and adjusts shaper cutter
or router bit to desired height.
3.
Adjusts fence to desired position then locks it
in place.
4.
Checks outfeed side of machine for proper
fence support and to make sure workpiece
can safely pass through cutter/bit without
interference.
5.
Removes any clothing, apparel, or jewelry
that may become entangled in shaper.
6.
Puts on safety glasses, respirator, and hear-
ing protection.
7.
Turns machine ON.
8.
Verifies cutter rotation and feed direction.
9.
Feeds workpiece through the cut while main-
taining firm pressure on workpiece against
both table and fence, while always keeping
hands and fingers out of the cutting path.
10. Turns machine OFF.
-21-
Advertisement
Table of Contents
