Adjusting Profile Roller Height - Grizzly G0767 Owner's Manual

Adjusting Profile
Roller Height
To produce an accurate notch, the center of the
profile roller must be even with the center of the
tube when mounted in the vise (see Figure 39).
Roller Support
Figure 39. Profile roller and tube even with each
other.
The correct height of the profile roller depends on
the height of the roller support bracket. This was
set properly at the factory. However, if you deter-
mine that the center of the profile roller is not even
with the center of the tube when mounted in the
vise, perform the following procedure to adjust it.
Model G0767 (Mfd. Since 1/14)
Bracket
Tool Needed
Hex Wrench 8mm .............................................. 1
To adjust roller support bracket height:
1. DISCONNECT MACHINE FROM POWER!
2.
Properly mount a tube in vise.
3.
Loosen the two roller support bracket cap
screws shown in Figure 40.
Cap Screws
Figure 40. Location of roller support bracket cap
screws.
4. Move profile roller up or down to center pro-
file roller with center of tube.
5. Retighten the two cap screws loosened in
Step 3.
Qty
-31-