Table of Contents
Advertisement
Assembly
Before beginning, refer to Needed for Setup sec-
tion and gather all applicable items. Ensure all
parts have been properly cleaned of the heavy-
duty rust-preventative applied at the factory. Refer
to Cleanup on Page 15 for more information.
To assemble shaper:
1.
Lay one stand side on ground and attach both
cross braces with (8) M8-1.25 X 10 carriage
bolts, (8) 8mm flat washers, and (8) M8-1.25
hex nuts, as shown in Figure 10. DO NOT
fully tighten nuts and bolts at this time.
x 4
Figure 10. Attaching cross braces to stand side.
2.
Attach remaining stand side to other end of
cross braces. Stand assembly should now
look similar to Figure 11.
Figure 11. Stand fully-assembled.
Model G0510ZW (Mfd. Since 9/16)
3.
Thread rubber feet into stand bottom, as
shown in Figure 11.
4.
Place shaper table upside down on (2) 20"
4x4 blocks, as shown in Figure 12. Spindle
may need to be retracted to avoid contact
with ground by releasing spindle elevation
lock and turning elevation lever.
Note: Make sure the spindle DOES NOT
touch the ground or the weight of the shaper
may damage the spindle.
5.
Place stand assembly on shaper and attach
with (8) M8-1.25 x 20 carriage bolts and (8)
8mm lock washers, (8) 8mm flat washers,
and (8) M8-1.25 hex nuts (see Figure 12).
x 4
Figure 12. Attaching stand to shaper unit.
6.
Have an assistant help you turn shaper unit
rightside-up.
7.
Level shaper by adjusting rubber feet, then
fully tighten all nuts and bolts on stand.
Note: Sheet steel will often "spring" after it
has been fabricated at the factory, which can
make lining up parts difficult. If parts do not
seem to work together, try switching parts
around (such as cross braces).
Rubber
8.
Place fence assembly over threaded studs
Foot
pre-installed in shaper table.
-17-
Advertisement
Table of Contents
