Grizzly G0510ZW Owner's Manual page 42

4. Loosen and remove taper nut (see Figure
56), while holding spindle top with an 8mm
wrench.
Taper Nut
Figure 56. Removing taper nut from drawbar
(located beneath table).
5.
Gently tap bottom of drawbar with wrench to
knock spindle loose.
6. Remove spindle/drawbar assembly from
spindle cartridge.
7. Place desired collet into collet nut by pushing
it in until it snaps (see Figure 57).
Figure 57. Collet snapped into collet nut.
-40-
8.
9.
10. Place table over spacers and secure it to
Collet Nut
Collet
11. Keep removed table bolts for when convert-
Insert collet assembly into spindle cartridge,
and tighten until collet nut and collet are flush
on top, as shown in Figure 58.
Surfaces Are Flush
Figure 58. Collet flush with top of collet nut.
Place table spacers over table mounting
holes (see Figure 59).
shaper with hex bolts from router table spacer
kit (see Figure 59).
7 Spacers
Figure 59. Installing table spacers to convert
shaper to router table
ing back to use as a shaper.
Model G0510ZW (Mfd. Since 9/16)
Tighten Until
5 Long Bolts
2 Short
Bolts