Grizzly G0510ZW Owner's Manual page 20

9. Use (2) 8mm flat washers and star knobs to
secure fence assembly to table (see Figure
13).
10. Mount fence faces to fence assembly with (4)
M8-1.25 x 12 Phillips head screws, (4) 8mm
flat washers, and (4) M8-1.25 hex nuts, as
shown in Figure 13.
Note: Heads of screws must be below sur-
face of fence face.
x 4
Figure 13. Mounting fence faces to fence
assembly.
11. Place a straightedge against fence faces, and
align them as close as possible using fence
offset knob (see Figure 14).
Fence
Offset
Knob
Straightedge
Figure 14. Checking fence alignment with
straightedge.
-18-
12. Inspect entire length of both fences to ensure
13. Insert mounting post into post bracket on
14. Secure attachment bar to mounting post
15. Attach safety guard to bar with (2) M4-.7 x 10
x 2
IMPORTANT: Once setup, the safety guard height
adjusts by loosening the star knob that secures
the mounting post. Always position the safety
guard as close to the cutter as possible without
interfering with your work.
they properly align with each other.
— If the fences do not properly align with
each other, they must be shimmed or
resurfaced on a jointer.
Note: This is an important step. If the fences
will not properly align with each other, you will
not get accurate cuts.
rear of shaper table, and tighten star knob to
secure mounting post (see Figure 15).
with (2) M8-1.25 x 12 hex bolts and (2) flat
washers (see Figure 15).
Phillips head screws and (2) M4-.7 hex nuts.
Completed safety guard assembly should
look similar to Figure 15.
AMPUTATION HAZARD!
Safety guard reduces risk
of accidental contact with
rotating cutter and protects
operator from flying debris.
It MUST be installed.
Guard
Star
Knob
Attachment
Bar
Figure 15. Safety guard components correctly
assembled on shaper.
Model G0510ZW (Mfd. Since 9/16)
Mounting
Post