Spindle Height; Fence Adjustment - Grizzly G1035 Owner's Manual

7. Tighten the nuts while holding the spindle
stationary. Use a wrench on the notches at
the top of the spindle for leverage, as shown
in Figure 36.
8.
Replace the main guard.
Figure 36. Tightening spindle nuts.

Spindle Height

To adjust the cutter height:
1. Loosen the spindle height lock (see Figure
37).
2. Move the spindle up or down with the eleva-
tion handwheel until the desired position is
obtained.
3. Lock the spindle into position.
Figure 37. Spindle height lock.
-28-

Fence Adjustment

The fence is a two-piece adjusting system. Each
fence is independently adjustable to compensate
for different cutting thicknesses and special shap-
ing applications. One turn of a fence knob moves
each fence approximately
To adjust the fence:
1. Loosen the fence lock handle (see Figure
38).
Figure 38. Fence adjustments.
2. Turn the fence adjustment knob (see Figure
38) until the fence is set to the desired posi-
tion.
3. Tighten the fence lock handle.
More detailed information concerning fence
adjustments is covered in Straight Shaping on
Page 30.
Model G1035/G1035P (Mfg. Since 4/10)
/ " (.078").
5
64
Adjustment Knob
Lock Handle