Temperature Sensor (Rtd) Removal; Side Trim And Side Panel Removal; (Right Side Shown) - Viking DCCG130 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Temperature Sensor (RTD) Removal

Condition Requirements:
Door Assembly Removed
Back Panel Removed
Control Components Accessed
Note: The following procedure explains how to
replace the RTD properly. An option to this
procedure would be to pull the RTD through
the oven cavity, cut the two wires, and splice
in the replacement RTD with the use of two (2)
ceramic wire nut connectors.
1. Disconnect RTD Molex connector in burner box area.
2. Remove any wire ties as required.
3. Route RTD wires through burner box area and out
back of range.
4. Remove any wire ties as required.
5. Remove screws and RTD sensor from the oven liner.
6. Reverse procedure for installation.
28

Side Trim and Side Panel Removal

(Right side shown)

Condition Requirements:
Control Panel Assembly Removed
Door Assembly Removed
Island Trim Removed
1. Remove screws and lift kick plate from keyhole
screws.
2. Remove screws and side trim from range.
3. Remove keyhole screw from front of range.
4. Remove screws from back of range.
5. Remove screws, main top support, and side panel
from range.
6. Reverse procedure for installation.
©2010 Viking Preferred Service