4 INSTALLATION
4.1 General
The equipment must be installed by trained and qualified professionals.
WARNING!
This product was designed for industrial use. The user is responsible for taking the appropriate measures.
4.2 Environment
This equipment was designed for use in environments with higher risk of electric shock.
A. The examples of environments with higher risk of electric shock include:
1. Areas in which freedom of movement is restricted, and the operator is forced to work in a limited position
(on his knees, sitting down, or laying down) with physical contact with conductive parts.
2. Areas completely or partially limited by conductive elements and in which there is high risk of inevitable
or accidental operator contact.
B. Environments with higher risk of electric shock do not include areas in which conductive parts close to the
operator, which could cause elevated risk, have been insulated.
4.3 Workplace
To operate the equipment safely, ensure that the workplace:
A.
40 C
0 C
D.
4.4 Power grid requirements
The power grid voltage must be within ±10% of the rated power grid voltage. If the real power grid voltage is
outside this range, the welding current may change causing internal component failure and impaired equipment
performance.
The cutting machine must be:
■
Installed correctly, by a qualified electrician.
■
Grounded correctly (electrically) according to the local standards. Refer to Local and National Codes or
local authority having jurisdiction for proper wiring requirements.
■
Connected to the power grid with a duly specified fuse.
12
B.
E.
C.
0-5584