Table of Contents
Advertisement
WARNING!
Do not operate this machine above its rated capacity.
WARNING!
The air supply must be free from oil, humidity, and other contaminants. Excessive oil and humidity may cause double arcs, quick
tip wear, or even complete torch failure. Contaminants may cause poor cutting performance and quick electrode wear. Optional
filters provide higher filtering capacity.
NOTE!
The IEC Classification is determined as specified by the International Electrotechnical Commission. These specifications include
the output voltage calculation based on the equipment rated current. To allow easy comparison between pieces of equipment,
all manufacturers use this output voltage to establish the operation cycle.
NOTE!
The weight includes the equipment, torch, consumables, input power cable, and work clamp.
3.1 Generator Recommendations
When using generators to power the plasma cutting system, the following minimum specifications must be
considered to select the power generator.
TABLE 3.2
HandyPlasma 35i
HandyPlasma 45i
0-5584
176 mm
324 mm
415 mm
13.5 kg
15"
381 mm
Figure 3.1 - Dimensions and weight of the power supply
MODEL
Art # A-14040DIFF_2
GENERATOR RATED OUTPUT
8 kVA (with power factor of 0.8)
6.4 KW (with power factor of 1.0)
9 kVA (with power factor of 0.8)
7.2 KW (with power factor of 1.0)
11
Advertisement
Table of Contents
