Power Supply Cables - ESAB HandyPlasma 35i Operating Manual

WARNING!
All electrical work must be performed by a qualified expert electrician.
WARNING!
The grounding terminal is connected to the power supply body via the HandyPlasma plug. It must be connected to a grounding
point of the workplace electrical installation. Take care not to invert the input cable ground conductor (green/yellow cable) at
any of the main switch of circuit breaker phases, because this applies electrical voltage to the body.
NOTE!
Do not use the network neutral as ground.
All electrical connections must be firmly tightened in order to avoid risk of sparks, overheating, or circuit voltage
drop.

4.5 Power supply cables

NOTE!
The HandyPlasma equipment includes an appropriate input power cable to supply the 220~240 VAC single-phase input.
Customer is responsible for connecting the HandyPlasma to the appropriate voltage range from the grid. Attempting to plug in
voltage ABOVE this range will cause damage.
When the equipment input voltage is below the safe operation range, the Voltage Error Screens are displayed when
the cutting process is initiated.
If the power supply voltage exceeds the safe work voltage range continuously, the equipment service life may be
reduced.
0-5584
Figure 4.1 - HandyPlasma power supply
13