Table of Contents
Advertisement
In the 2T mode, the torch trigger must remain pressed to activate the cutting output.
The 4T mode is used mainly for long cutting operations in order to reduce operator fatigue.
2) CUTTING MODE SELECTION SCREEN
To enter the cutting mode selection.
To confirm the selection.
To exit the cutting mode selection screen.
Figure 5.13 - Plate cutting mode
22
Figure 5.12 - Cutting mode selected
To change the selection between the plate cutting mode and the grid mode.
When the cutting mode is highlighted.
Figure 5.14 - Grid cutting mode
0-5584
Advertisement
Table of Contents
