Table of Contents
Advertisement
OVERHEATING ERROR SCREEN
The cutting equipment is protected by a temperature sensor. The overheating error screen is displayed if the
machine is overheated, which normally occurs if the equipment work cycle is exceeded.
If the overheating error screen displays the machine output, it shall be deactivated. Let the equipment ON
to allow the internal components to cool down. When the equipment is cool enough, the overheating error
screen disappears automatically.
Notice that the ON/OF switch must remain in the ON position, so that the fan continues to operate and allow
the equipment to cool down enough.
In case of overheating, DO NOT
.
Figure 5.21 - Overheating error screen
TORCH PART SELECTION
Inspect the torch regarding appropriate assembly and parts. The torch parts must correspond to the current
type of work operation. Only use original ESAB parts.
Washer
Diffuser
Electrode
Cutting nozzle
Shield Cup
Standoff Guide
Worn electrode
Worn nozzle
0-5584
25
Advertisement
Table of Contents
