ESAB HandyPlasma 35i Operating Manual page 23

Note that when the trigger mode is defined as 4T, the grid cutting mode is not available.
In the plate cutting mode with the trigger mode 2T selected, the arc stops when the torch is pulled away from the
workpiece during the cutting operations.
To restart the pilot arc.
In the grid cutting mode, when the torch is pulled away from the workpiece, the pilot arc is restarted instantaneously
and the cutting arc activates instantaneously when the pilot arc gets in contact with the workpiece. It is advisable to
select the grid cutting mode to cut expanded metal or grids or to perform grinding operations, when uninterrupted
reinitialization is desired.
3) GAS PURGE SCREEN
Figure 5.15 - Gas purge screen selected Figure 5.16 - Gas purge screen selected
4) MAIN SCREEN
When the main screen is highlighted to enter the main screen.
To exit the menu screen.
TORCH INSTALLATION OR COVER ASSEMBLY ERROR SCREEN
The torch installation or incorrect cover assembly error screen is displayed when the torch or torch
consumable are not installed correctly.
Check the torch and consumable installation.
Figure 5.17 - Torch or consumables installation error screen
0-5584 23