Erase The Settings - NETGEAR WAC104 User Manual

3. Release the Reset button.
The configuration is reset to factory default settings. When the reset is complete,
the AP reboots. This process takes about two minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset.
For example, if you are connected to the AP local browser UI, do not close the
browser, click a link, or load a new page. Do not turn off the AP. Wait until the AP
finishes restarting and the Power LED remains solid green.

Erase the settings

CAUTION: This process erases all settings that you configured in the AP.
To erase the settings:
1. Connect your computer or mobile device to the AP in one of the following ways:
• Connect directly to the AP's WiFi network or LAN.
• Connect to the same network that the AP is connected to.
2. Launch a web browser and enter http://www.aplogin.net (or aplogin.net) in the
address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use aplogin.net on page 24.
A login window displays.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The Home page displays.
4. Select Administration > Backup Settings.
The Backup Settings page displays.
5. Click the Erase button.
The configuration is reset to factory default settings. When the reset is complete,
the AP reboots. This process takes about two minutes.
Manage the AP and Monitor the
Traffic
802.11ac Wireless Access Point Model WAC104
56 User Manual