Erase The Current Configuration Settings; Set Password - NETGEAR WNDR4300-TN User Manual

N750 Wireless Dual Band Gigabit Access Point WNDR4300-TN

Erase the Current Configuration Settings

You can use the Erase button to erase the configuration and restore the factory default
settings. You might want to do this if you move the access point to a different network or if
you changed the password and have forgotten what it is. (The default password is on the
product label.)
You can also use the Restore Factory Settings button on the back of the access point to
erase the configuration and restore the factory settings. (See

To erase the configuration settings:
1. Select ADVANCED > Administration > Backup Settings.
2. Click the Erase button.
The factory default settings are restored. The user name is admin, the password to
password, and the LAN IP address is 192.168.0.51. DHCP is enabled.

Set Password

You can change the default password that is used to log in to the access point with the user
name admin.
This is not the same as changing the password for wireless access. The label on the bottom
of your access point shows your unique wireless network name (SSID) and password for
wireless access (see

To set the password for the user name admin:
1. Select ADVANCED > Administration > Set Password.
2. Type the old password and type the new password twice.
3. If you want to be able to recover the password, select the Enable Password Recovery
check box.
4. Click the Apply button.
Your changes take effect.
Label on page 8).
Administration
32
Factory Settings on page 43).